Tag Archives: washing construction equipment

How to clean a machine with a power washer

Heavy equipment have to go through a lot of dirt and stains on a daily basis. The kind of work it goes through can only suggest the amount of mud it has all over its body and through that one can also understand the mud it has eaten and must be rotting inside its body. It is said that heavy equipment should be cleaned on a regular basis and if not done then there are higher chances of it getting damaged. People spend a lot for buying a machine and they can’t see it rotting just because it has eaten a lot of dirt and the guys are finding it hard to remove it from the machine.

Well, there is a very simple solution to this problem and that is to clean the machine using a power washer. It is also known as “Pressure Washer”. It gives you the access to reach those areas which are ideally not possible for human hands to reach. Well, in order to clean the interiors of the machine, you do not have to open apart each and every piece of it and then spray the dirt out. All you can do now is just use the power washer and get rid of stains and dirt that is in and around the machine.

It is also very simple to use a power washer and can be done by you or by your children (only if they are young enough to understand how it works). Also, it does not put a lot of stress on you. You have to select the time on the power washer that you think you will take to wash the entire machine and you also got to make sure that you have sufficient gallons of water that will sustain till the time you are cleaning the machine. The garden hose should be ¾-in diameter as that should suffice to connect to the washer’s inlet. You also got to make sure that you have tightened the hose connection so that no air passes in the line.

You need to ensure that you have set the spray want to 0 pressure so that there are no kick-backs when the power washer is started. Once you are done with this, you have to turn on the water faucet completely. Once you do that, slowly squeeze the spray wand so that you can wash out the air from the stuff. You can then start the engine and allow it to warm-up for a minute after which you can adjust the pressure and the settings on the spray making it ready to shoot water.

While you are working on the power washer, it is advisable that you keep the user manual handy as different power washers work differently. So you may need them when you are actually working with it. You may also ready it first and then try the washer. It may seem difficult but the moment you use it for the first time, things will turn out to be quite smooth for you.